Could someone who has an empty spool please give use the weight of that empty spool so we can enter correct values for spools which are not brand new.Ģ. The Computer-Aided Design ('CAD') files and all associated content posted to this website are created, uploaded, managed and owned by third party users. Selecting NO will cause the print to start and you will either run out of material before print completion or you simply had the wrong weight set for the spool and it will print fine.ġ. If you click yes then printing will not take place and you can replace the spool so that you have enough material to print OR go set the spool weight if you have never set this parameter before. If you have not set it since you installed the new software version you will see this alert message. Use "New Spool" button in maintain dialog box to input new spool weight(default is 700 gram), and the up software automatically decrease the material weight. So it needs to know the weight of material on the spool which you must set as per instruction below. ![]() Measure X1,X2 on platform and Z off platform(Z is +/-, see the pic on dialog box, right is -value, left is. M206 X-180 offset X axis so the coordinates are 0. After print the cailibration model, then measure the size of X1, X2( left the model on platform), Z(remove the front L part from platform),and leave H with 40 if you didn't scale the model. My understanding is that it basically calculates this based on the current weight of material on the spool and how much it thinks its laying down through the nozzle. in the machine settings I've set all the print-head settings to 0, haven't experimented with that - start Gcode: G28 Z-2 home Z axis (first for safety) G28 X-2 Y2 home X Y axes. In the software, if you choose Reset to Default, the software will reset the main parameters back to the factory settings: Printer Name, 9-point bed leveling offsets, nozzle height set to 0, the value of nozzle offset, print material and the weight set to default values. If it is slightly too high or low you can add or remove height in the offset setting in print settings. This is a good guide I’ve been following for years. The new software 1.0.8 keeps track of the material used in order to alert you if it thinks there is not enough ABS on the spool to complete your print. Currently, the printer can print fine along the center of the print bed, however it begins to under-extrude on one side and over-extrudes on the other. The model’s thickness is smaller than the Layer thickness setting. ![]() Resize the model or put the model back into the printable range. If model going beyond any of the xyz axis range, this error will occur. Model is bigger bigger than the print volume. ![]() "Print Material not enough, add material?" Three possibilities that could cause the out of boundary issue. TeamTeamUSA wrote:What does this dialog mean?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |